2008 Citroen C1 Vibe 1.0
Summary:
Basic, cheap but characterful transport
Faults:
Nothing has gone wrong so far, though engine more mechanically noisy than you'd expect for a new design, maybe due in part to minimal sound deadening.
General Comments:
Don't confuse low cost with excellent value! Although the C1 is generally the cheapest of the C1/107Aygo family, it is very spartan inside, especially in Vibe trim. That said there is nothing missing that you actually miss after a while and less gizmos means less to go wrong.
Ride is surprisingly firm, but enjoyable unless you prefer a very soft chassis. Engine is keen, though not particularly torquey even taking it's capacity into account. A 1994 1.0l Polo I drove recently felt much more gutsy at the bottom end for example.
Economy is quite incredible, never had under 60mpg, and a recent tankful consisting almost completely of slow (55mph) cruising returned just over 70mpg. 65mpg quite normal for longer journeys. With diesel over 12p/litre more expensive now, small petrols like this make most sense if the pennies are tight.
Servicing is expensive full stop. 10k intervals and they're no cheaper than any other car, expect £180 from a main dealer.
Bizarre recommendation from dealers to use a mineral 15W-40 oil. No obvious reasons, though other similar Toyota/Daihatsu engines have been known to start using oil fairly early (40k) so this maybe an admission of potential oil consumption problems, time will tell.
Would you buy another car from this manufacturer? Yes
Review Date: 15th May, 2008
4th Jun 2008, 08:48
Glad you like the car. I agree that there are better value cars out there, but only because other vehicles like the Ka are of a much older design, or are much more readily pre-registered by dealers etc. For a brand new city car, I reckon the price is fair, particularly when you compare the cost of fuel, tax etc to the likes of the Ka or even the Panda.
Most new cars should run good quality mineral oil for at least the first two services to allow the engine to 'bed in' properly - let the pistons remove the hone marks from the bores etc. After this, it is good to switch to a decent semi-synthetic, although fully-synthetics can be a little too thin on a non high-performance engine like this. Bedding the engine in properly will improve long-term oil consumption and reliabilty, so your dealer's advice is probably sound.